Fiery KM-C3130 Configuration Manual page 92

4
4-34 Performing Setup from the Control Panel
Use Automatic Configuration
Yes/No [Yes]
This option appears if you chose DHCP or BOOTP as the protocol for automatically
obtaining the IP address of the Fiery S300.
Choose Yes and the Fiery S300 uses a WINS name server and automatically obtains its
IP address. Make your choice and proceed to the Server Name option.
Choose No to proceed to the Use WINS Name Server option, where you specify
whether to use a WINS name server, and then to the WINS IP Address option, where
you specify its IP address.
Use WINS Name Server
Yes/No [No]
Broadcasts from SMB devices cannot pass across a router without a WINS name
server. Setting up the WINS name server is outside the scope of this manual. To find
out if a name server is available, contact your network administrator.
WINS IP Address
[127.0.0.1]
This option appears only if you choose Yes for WINS Name Server. Change the default
address to the correct IP address for the WINS Name Server. Obtain the correct
address from your network administrator.
Server Name
Default Name
The server name is the name that will appear on the network for accessing the
Fiery S300 via SMB. The default name is the same as the server name assigned in
Server Setup (see
Server Comments
Server comments (optional) can contain information about the printer. These
comments are listed in the Fiery S300 Properties in Network Neighborhood and
can be up to 15 characters.
page 4-14).