Fiery KM-C3130 Configuration Manual page 75

4
4-17 Network Setup options
For this Network or
Connection Type
AppleTalk over Ethernet
TCP/IP over Ethernet
IPX/SPX over Ethernet
T N
O ACCESS
1. Confirm that the network cable is connected to the Fiery S300.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
5. When you have finished entering port settings, choose Exit Port Setup, and then
6. Enter the appropriate settings for the protocol(s) you will use.
If the Fiery S300 is configured to enable more than one protocol, it automatically
switches to the correct protocol when it receives a print job.
The available network types, and the Setup areas that pertain to them, are summarized
in the following table.
Use this
Port Setup
Ethernet Setup AppleTalk Setup
Ethernet Setup TCP/IP Setup: Ethernet Setup
Ethernet Setup IPX/SPX Setup
S
ETWORK ETUP OPTIONS
During Network Setup, the Fiery S300 queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
appropriate settings.
choose Protocol Setup.
Use this
Protocol Setup
AppleTalk printing (PAP) is
enabled automatically.
LPD Setup
Web Services Setup
Windows Setup
Port 9100 Setup
(Windows 2000/XP)
PServer Setup (NDS, Bindery,
or both)
Use this
Service Setup