Craftsman 113.239420 Owner's Manual page 18

3. The starting pin must be used as a pivot to support the
work until it has been fed into the shaper collar. The
Starting Pin may be located in either of the two threaded
holes near the table insert opening, depending upon the
direction of rotation, but always on the in-feed side.
4 Start the workpiece by pivoting it around lhe starting pin
slowty into the path of the culter until the workpiece
contacts the shaper collar,
WARNING: Do not attempt to shape warped lumber.
Workpiece MUST contact the FRONT of the cutter and
collar - toward the miter gauge slot.
5. In addition,11he following operations are some which can
be performed on the shaper - shaping with a pattern,
tongue and groove joints, reading and fluting, etc. ("Power
Tool Know How" Handbooks are available) See Recom-
mended Accessories list.
NOTE: Alter a few hours of operation, tighten both pulley set
screws securely with the Hex wrenches provided.
PIVOT WORKPIECE
AROUND STARTING PiN
COLLAF_
_8