Getting To Know Your Wood Shaper; On/Off Switch - Craftsman 113.239420 Owner's Manual

GETTING TO KNOW YOUR WOOD SHAPER
8
FENCE
LOCK KNOB
9
FENCE FACE
TABLE
INSERT
MITER GAUGE
SLOT
TABLE
10
CUTTER GUARD
PIN
FE NCE
ADJUSTING KNOB
8 FENCE
LOCK KNOB
2
ELEVATING
CONI_OL LEVER
!
ON-OFF SWITCH
\
MOTOR MOUNT PLATE
FENCE FACE
SPINDLE
LOCK KNOB
MOTOR (NOT
FURNISHED)
MOTOR ROTATION
The motor equipped with the shaper is designed to be
operated in a clockwise or counterclockwise rotation by use
of a select switch Eocated on the motor, Before the motor is
turned on, move the serect switch "up" for clockwise
rotation or "down" for counterclockwise rotation. The
direction of rotation cannot be changed while the motor is
running, Turn the motor off and wait until the motor has
stopped completely before selecting the desired rotation.
WARNING: Once the motor rotation has been selected
always check to be sure the spindle is rotating in the
correct direction for the cutter being used.
1. ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the cutter
is installed properly and the keyed washer is positioned
below the spindle nut.
The On-Off SwiIch has a locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE 8Y CHILDREI_ AND
OTHERS,
a° TO turn Shaper ON... insert finger under switch lever
and pull END of lever out.
After turning switch ON, always allow the cutter to
come up to full speed before cutting.
Oo not cycle the motor switch on and off rapidly, as
this may cause the cutter to loosen, in the event this
should ever occur, allow the cutter to come to a
complete stop and retighten the spindle nut normally,
not excessively. Never leave the shaper while the power
is "ON".
b. TO turn shaper OFF... PUSH lever in. Never leave the
shaper until the cutting tool has come to a complete
stop.
= ;12
i
@
KEY
(YELLOW PLASTIC)
KEY