Cable, CompactFlash and Accessory Specifications
Installing Shunt/Terminal Strip
To install the shunt or terminal strip, attach two dual‐pin units vertically to each four‐pin jumper
(P2, P3, P4, or P5) corresponding to the RJ‐48C port using a balun, as shown in Figure
A‐16. Any
other RJ‐48C5 ports on the NIM card connected to 120‐ohm lines do not require shunts.
Figure A-16
Installing a Grounding Shunt on the E1 NIM Card
XSR Getting Started Guide A-13