Sharpening Cutter Knives; Installing (Replacing) Cutter Guard Spring - Craftsman 113.232210 Owner's Manual

N(_ irtsta!! bothlockingsetscrewsandtighten(with
tt_e5/32_'Hex:L Wrench)alternately a little:at a:time.
..... t igi_tenboth: Screws securely.; Recheck:the blade
::"i: t o make sure it didonot change _sitioni:: : ::i
-!4:1 =l_stai! the other: twokiiiveS
_ i5: Ret_stail the belt guaid,; sliding guard, and slid ng
.... guard knob. ::. :
CAUTION=THE CUTTER KNIVES ARE VERY SHARR
TO PREVENT A SLIP OF THE HAND WHICH COULD
CAUSE CUTTING OF YOUR HAND, ALWAYS HOLD
ONTO THE CUTTERHEAD PULLEY TO PREVENT
ACCIDENTAL ROTATION OF THE CUTTERHEAD. _ __
SHARPENING CUTTER KNIVES
The knives can be honed individually with an ordinary
oilstone,
Make sure your oilstone is not worn in the center. It
must be flat.
Besure to remove the burr on the flat side.
11/16 IN.
NEW BLADE
if the knives are nicked, they must be replaced or re-
ground:: They can be regrounded several times until
they become 9/16 in. wide: Never install reground
knives less than 9/16 in, wide 0r unbalanced knives_
.
ave your knives reground by s0m_0newho:iscompe-
tent. I_ooki_: the Yellow Pages 'of your:telephonedirec_
tory :i .:;:!See::,SharpeningService's." .......... _= -
34