Adjusting Guard Spring; Attaching Pulley Guard; Installing Rear Cutter Head Guard; Adjusting The Leveling Feet - Craftsman 113.232240 Owner's Manual

Assembly (continued)
Adjusting Guard Spring
1. Remove the pan head screw from bottom of the guard post,
2. Remove tension on.guard by turning tension knob
clockwise. Pull up on guard to remove.
3, Add tension to the cutter head guard in 1/2 turn incre-
ments by turning the tension knob and reinserting the
guard post.
4. Repeat Cutter Head Guard Functional check as previ-
ously described.
NOTE: Do not overtighten the spring, Overtightening
may cause premature spring or guard breakage, If the
guard or spring breaks or malfunctions, do not use the
tool. Replace the defective parts before the tool is put
back in service.
When the adjustment is complete, reinstall the pan head
screw in the bottom of the guard post.
Attaching Pulley Guard
!. From among the loose parts, find the following:
Description Qty.
Pan Head Screw 1/4-20 x 1/2 ............................. 4
Washer 1/4 ......................................................... 4
Pulley Guard ....................................................... 1
Cover: ................................................................. 2
2. Attach the upper pulley guard to the stand with the 4
screws and washers.
3. Install side covers into place with the clips facing
toward the outside. Turn the clips to lock in place.
Cover
Installing Rear Cutter Head Guard
1. From among the loose parts, find the following:
Description Qty.
Rear Guard ......................................................... t
Screw Pan Head 1/4-20 x 1/2 ...................... :...... 2
Washer 1/4 ......................................................... 2
2. Hold guard in place and fasten to jointer fence assem-
bly with the two screws and Iockwashers as shown.
Pulley
Guard
Adjusting the Leveling Feet
Move the jointer/planer to the location where it wil! reside
during use.
Level the legset, loosen top nut and turn bottom nut to
raise or lower feet. Using two open wrenches or adjust-
able wrenches, adjust all four leveling feet if necessary
and then tighten the nuts.
NOTE: These levelers are not intended for height adjust-
ment, only leveling adjustment,
16