Network Connection; Home Network - Sony STR-DN1040 Operating Instructions Manual

Network connection

Cannot connect to the WPS via a
wireless LAN connection.
• You cannot connect to a network using
WPS when your access point is set to
WEP. Set up your network after
searching the access point using the
access point scan.
An error message appears.
• Check the nature of the error. See
"Network features message list"
(page 76).
Cannot connect to the network.
• Check the network status. See
"Connection Status" in "Information"
in Network Settings menu (page 101).
If "Not connected" appears, set up the
network connection again (page 39).
• When the system is connected through
a wireless network, move the receiver
and the wireless LAN router/access
point closer to each other and do the
setup again.
• Check the settings of the wireless LAN
router/access point and do the setup
again. For details on the settings of the
devices, refer to the operating
instructions of the devices.
• Make sure that you use a wireless LAN
router/access point.
• Wireless networks are influenced by
electromagnetic radiation emitted by
microwave ovens and other devices.
Move the unit away from these
devices.
• Make sure that the wireless LAN
router/access point is turned on.
Cannot control the receiver using the
TV SideView device.
• The receiver may take a long time to
connect to the network after you turn
on the receiver. Wait for a few
moments, and then try using the TV
SideView again.
• Make sure "Network Standby" is set to
"On" in the Network Settings menu so
that you can use the TV SideView
immediately after you have turned on
the receiver.
Cannot select the Network Settings
menu.
• Wait for a few moments after you
turned on the receiver, and then select
the Network Settings menu again.

Home Network

Cannot connect to the network.
• Make sure the wireless LAN router/
access point is turned on.
• Make sure the server is turned on.
• The network settings on the receiver
may be incorrect. Check the network
status. See "Connection Status" in
"Information" in Network Settings
menu (page 101).
If "Not connected" appears, set up the
network connection again (page 39).
• The server may be unstable. Restart it.
• Confirm that the receiver and the
server are connected to the wireless
LAN router/access point correctly.
• Confirm that the server has been set
correctly (page 61). Confirm that the
receiver has been registered to the
server and allows the music streaming
from the server.
• When the system is connected to the
wireless network, move the receiver
and the wireless LAN router/access
point closer to each other.
121
US