Usb Device - Sony STR-DN1040 Operating Instructions Manual

There is a time gap between the audio
output and visual display.
• Check that the PARTY STREAMING
function is not being used. To close a
PARTY, press PARTY CLOSE until
"CLOSE PARTY" appears. For
details, see page 73.
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not
supplied) to connect the receiver to an
outdoor FM antennas (aerial) as shown
below.
Outdoor FM antenna (aerial)
Receiver
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the
antennas (aerials) and connect an
external antenna (aerial), if necessary.
• The signal strength of the stations is
too weak with automatic tuning. Use
direct tuning.
• Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 53).
• No stations have been preset or the
preset stations have been cleared
(when tuning by scanning preset
stations is used). Preset the stations
(page 54).
• Press AMP, then press DISPLAY
repeatedly on the remote control so
that the frequency appears on the
display panel.
iPod/iPhone
The sound is distorted.
2
• Press – on the remote control
repeatedly. You can also use
MASTER VOLUME on the receiver.
• Set the "EQ" setting of the iPod/
iPhone to "Off" or "Flat".
There is no sound from the iPod/
iPhone.
• Disconnect the iPod/iPhone and
connect the iPod/iPhone again.
The iPod/iPhone cannot be charged.
• Check that the receiver is turned on.
• Make sure the iPod/iPhone is
connected firmly.
The iPod/iPhone cannot be operated.
• Check that you have removed the
protect case of the iPod/iPhone.
• Depending on the contents of the iPod/
iPhone, it may take time to start
playback.
• Turn off the receiver, then disconnect
the iPod/iPhone. Turn on the receiver
again and reconnect the iPod/iPhone.
• You are using an unsupported iPod/
iPhone. See "Compatible iPod/iPhone
models" (page 47) for the supported
device types.
The ringtones volume of the iPhone
does not change.
• Adjust the ring volume using the
controls on the iPhone.

USB device

Are you using a supported USB
device?
• If you connect an unsupported USB
device, the following problems may
occur. See "Compatible USB devices"
(page 49) for the supported device
types.
119
US