Using The Remote Control; Programming The Remote Control - Sony STR-DN1040 Operating Instructions Manual

Using the Remote Control

Programming the
remote control
You can customize the remote control to
match the equipment connected to your
receiver. You can even program the remote
control to operate non-Sony equipment and
also Sony equipment that the remote
control is normally unable to operate.
Before you begin, note that:
– You cannot change the settings of
TUNER, BLUETOOTH, USB, HOME
NETWORK, SEN, and SOURCE input
buttons.
– The remote control can only control
equipment that accept infrared wireless
control signals.
RM SET UP
TV
MEMORY
1
Hold down RM SET UP, then press
AV ?/1.
The RM SET UP button flashes
slowly.
108
US
2
Press the input button of the
equipment you want to program.
For example, if you want to program a
VCR connected to VIDEO 1 jacks,
press VIDEO 1.
The RM SET UP button lights up.
3
Press the numeric buttons to enter
the numeric code.
If more than one code exists, try to
enter either one which corresponds to
the equipment including TV.
Use the tables on page 109–112 to find
the numeric code(s) corresponding to
the equipment.
Note
Only the codes in the 500's are valid for the
TV button.
4
Press ENT.
Once the numeric code has been
verified, the RM SET UP button
slowly flashes twice and the remote
control automatically exits the
programming mode.
5
Repeat steps 1 to 4 to program
AV ?/1
other equipment.
Note
The RM SET UP button turns off while a numeric
Input
button is pressed.
buttons
To cancel programming
Press RM SET UP during any step. The
ENT
remote control automatically exits the
programming mode.
Numeric
buttons
To activate the input after
programming
Press the programmed button to activate
the input you want.
If programming is
unsuccessful, check the
following:
• If the RM SET UP button does not light
up in step 1, the batteries are weak.
Replace both batteries.