Input Buttons - Sony STR-DN1040 Operating Instructions Manual

A ?/1 (on/standby)
Turns the receiver on or sets it to the
standby mode.
If you press ZONE (
remote control to zone 2 mode, you
can turn the power for zone 2 on or off
using ?/1 (page 89).
Saving the power in standby mode
When "Control for HDMI", "Pass
Through", "Network Standby", and
"Bluetooth Standby" are set to "Off",
and the receiver in zone 2 is turned off.
1)
B AV ?/1
(on/standby)
Turns on or off the audio/video
equipment that the remote control is
programmed to operate.
To turn the TV on or off, press TV (
and then press AV ?/1.
Note
The function of the AV ?/1 changes
automatically each time you press the input
buttons (E).
C SLEEP
Press AMP (
4
set the receiver to turn off
automatically at specified time.
Each time you press SLEEP, the
display changes cyclically as follows:
0:30:00 t 1:00:00 t 1:30:00 t
2:00:00 t OFF
Tips
• To check the remaining time before the
receiver turns off, press SLEEP. The
remaining time appears on the display
panel.
• The Sleep Timer will be canceled when
you perform the following.
– Press SLEEP again.
– Update the software of the receiver.
– Press ?/1.
TV INPUT
U
Press TV ( ), then press TV INPUT
to select the input signal (TV input or
video input).
D AMP
Activates the receiver operation for
main zone (page 107).
16
US
T
) to switch the
), then press SLEEP to
E Input buttons
Selects the equipment you want to use.
When you press any of the input
buttons, the receiver turns on. The
input buttons are pre-assigned to
automatically control Sony equipment
when you select them. You can also
program the remote control to control
non-Sony equipment following the
steps in "Programming the remote
control" on page 108.
F HDMI OUTPUT (page 85)
G Numeric/text buttons
Press to
– preset/tune to the preset stations
(page 54).
– select track numbers. Press 0/10 to
U
)
select track number 10.
– select channel numbers.
– select the letters (ABC, DEF, etc.).
– select @ for the punctuation marks
(!, ?, etc.) or other symbols (#, %,
etc.) when you enter characters for
network features.
Press TV (
buttons to select the TV channels.
1)
ENT
Enters the value after selecting a
channel, disc, or track using numeric
buttons.
CHARACTER
Selects the character type for network
features.
Each time you press CHARACTER,
the character type changes in sequence
as follows:
"abc" (lowercase letters) t "ABC"
(uppercase letters) t "123"
(numbers)
1)
CLR
Press to
– erase a letter for network features.
– clear a mistake when you press the
incorrect numeric/text button.
1)
-/--
Selects channel entry mode, either one
or two digit.
2)
1)2)
U
), then press the numeric