Closing The Printer System Board; On The Right Side Of The Printer - Lexmark Optra Color 45 User Manual

Closing the Printer System Board on the
Right Side of the Printer
Complete the following steps after you install an option card:
1
2
3
4
5
Insert the four tabs on the top of the system board access
cover into the slots on the printer as shown.
Slide the system board access cover to the left until it
snaps into place.
Reconnect all cables to the back of the printer.
Reconnect the power cord to the printer and a properly
grounded electrical outlet.
Make sure the Ready message appears on the operator
panel display.
If an error message appears, see "Understanding Printer
Messages" on page 145.
Note: To verify that the option card is installed properly,
see "Verifying the Installation of Options" on
page 249.
Installing Options
Slots
Tabs
Chapter 9: Memory and Option Cards
243