Step 3: Install Memory And Option Cards; Accessing The Printer System Board - Lexmark T630 Setup Manual

Step 3: Install memory and
CAUTION:
If you are installing memory or option cards
sometime after setting up the printer, turn the printer off
and unplug the power cord before continuing.
Note:
Use a small Phillips screwdriver to remove the
system board access cover and to install some of the
cards.

Accessing the printer system board

option cards
Install memory and option cards
You can customize your printer memory
capacity and connectivity by adding
optional cards. The instructions in this
section help you install any of the
following options:
•
Memory cards
– Printer memory
– Flash memory
– Fonts
•
Firmware cards
– Bar Code
– ImageQuick™
– IPDS and SCS/TNe
– PrintCryption™
• Other options
– Printer hard disk
– RS-232 serial interface card
– Parallel 1284-B interface card
– MarkNet™ N2100 Series
You must access the printer system
board to install printer memory, flash
memory, or an option card.
30
internal print servers (also
called internal network
adapters or INAs)