Installing Options
Closing the Printer System Board under the
Input Tray
218
Chapter 9: Memory and Option Cards
Complete the following steps after you have installed the printer
memory option:
1
Reinstall the system board access cover.
a
While holding the cover at the angle shown, align the
tabs on the back of the access cover with the slots
located at the rear of the access opening.
b
Push down on the top of the access cover until it snaps
into place.
2
Reattach the input tray and output bin.
If you need help, see "Installing the Input Tray and
Output Bin Unit" on page 3.