Toner Level Sensor Removal; Transfer Roll Removal - Lexmark E330 Service Manual

Toner level sensor removal

(See "Electronics" on page
1. Open the right side cover. See
page 4-3
2. Unplug the cable from the sensor.
3. Unsnap the toner level sensor from the frame and remove
through the inside of the printer.

Transfer roll removal

(See "Frame" on page
1. Open the access cover.
2. At the right side of the transfer roll, squeeze the holder arms
with the left hand while lifting with the right. Stop when the
holder is unlatched.
3. At the left side of the transfer roll, squeeze the holder arms with
the right hand while lifting with the left hand. Stop when the left
holder is unlatched.
4. With a hand at each end, lift the transfer roll out. The springs
should remain in place.
Re-installation note: Verify the springs are inserted into the
bearings when re–installing.
for more information.
7-6.)
7-4.)
"Right side cover removal" on
Repair information
4505
4-13