Lexmark E330 Service Manual page 125

Left side cover removal
(See "Covers" on page
1. Open the access cover to expose a screw and the two left side
cover latches.
2. Remove the screw, which fastens the side cover.
3. Open the rear door (output tray).
4. Release the latches with the right hand while applying opening
force with the left hand.
5. Swing the cover open.
6. To remove the cover, position the printer with the left–rear
corner hanging over the edge of the table.
7. Lift the top rear of the cover over the pivot point and drop the
cover away from the printer.
Rear cover removal
(See "Covers" on page
1. Remove the right side cover. See
on page 4-3
2. Remove the left side cover. See
page 4-3
3. Open the rear door (rear exit tray) and remove the two screws
holding the cover.
4. Lift the rear cover, unhook it from the frame at the bottom and
remove.
Right side cover removal
(See "Covers" on page
Remove the right side cover the same way as the left side cover
except use the opposite hand. See
page 4-3 for more information.
Note: There is no screw holding the right cover.
7-2.)
7-2.)
for more information.
for more information.
7-2.)
"Right side cover removal"
"Left side cover removal" on
"Left side cover removal" on
Repair information
4505
4-3