Covers - Lexmark E330 Service Manual

4505

Covers

Access cover removal
(See "Covers" on page
1. Open the front access cover.
2. Place thumbs on the inside of the respective hinge.
3. Force the left hinge out of its socket and relax it above the
socket.
4. Force the right hinge out of its socket and lift it above the socket.
CAUTION: Do not pull the fuser link out of the printer any farther
than when the door is fully open. Otherwise, the link extension may
cause the cartridge coupler to become dislodged.
5. Carefully lift the cover free from the printer frame.
6. Use your left hand to hold the fuser link at the cover joint while
rotating the right side of the cover slightly away from the printer
to disengage the link.
7. Remove the access cover.
Reinstallation note: If the access cover is being replaced, remove
the logo plate and use it on the new cover.
Extender cover removal
(See "Frame" on page
1. Locate the latches on the left and right sides of the extender
cover.
2. Push the latches and pull the cover away from the rear of the
printer.
4-2
Service Manual
7-2.)
7-6.)