4505
Paper exit guide assembly removal
(see
"Frame" on page
1. Remove the rear cover. See
page 4-3
2. Remove the three screws holding the exit guide.
3. Remove the paper exit guide assembly.
Reinstallation note: It may be necessary to rotate the gears to
mesh with the fuser and drive gear.
Printhead removal
(See
"Electronics" on page
1. Remove the top cover. See
for more information.
2. Remove the controller card cover (two screws).
Note: Notice the alignment of the printhead at each screw.
3. Unplug the printhead cables at locations J11 and J12.
4. Remove three screws securing the printhead to the cross brace
and lift the printhead out.
Toner level sensor cable removal
(See
"Electronics" on page
1. Open the right side cover. See
page 4-3
2. Remove the controller card cover (two screws).
3. Unplug the sensor at J17 and extract the cable.
4-12
Service Manual
7-6.)
for more information.
for more information.
"Rear cover removal" on
7-4.)
"Top cover removal" on page 4-4
7-4.)
"Right side cover removal" on