Lexmark E330 Service Manual page 115

Setting
Reset
Photoconductor
Counter
* Factory default
Setup
Use the Setup menu to configure how the printer formats the
end of a line depending on the computer system being used.
Menu item
Demo mode
Auto CR after LF
Auto LF after CR
* Factory default
Use setting to:
Return the photoconductor counter to zero.
The replace photoconductor message should be
cleared only when the photoconductor kit has been
replaced.
Use setting to:
Put printer into demo
mode where internal
sheets prints with each
press of .
To deactivate, turn the
printer off and re-enter
configuration group. Set to
deactivate.
Specify whether the
printer automatically
performs a carriage return
after a line feed control
command.
Specify whether the
printer automatically
performs a line feed after
a carriage return control
command.
Values
Values
Deactivate*
Activate
Off*
On
Off*
On
Diagnostic aids
4505
3-7