Fuser Power Cable Removal; Fuser Removal - Lexmark E330 Service Manual

4505

Fuser power cable removal

(See "Electronics" on page
Note: The cable can be reached without fully removing the
card.
2. Remove the rear cover. See
page 4-3
3. Remove the exit guide assembly. See
assembly removal" on page 4-12
4. Remove the two screws (one on each side) from the lower
corners of the fuser.
5. Slide the fuser out far enough to expose and disconnect the AC
cable connections.
6. Extract the fuser power cable.

Fuser removal

(See "Electronics" on page
2. Remove the two screws (one on each side) from the lower
corners of the fuser.
3. Remove the controller card cover (two screws).
4. Disconnect the thermistor at J15 and exit sensor at J10 on the
controller card.
5. Slide the fuser out far enough to expose and disconnect the AC
cable connections.
6. Carefully extract the fuser with thermistor and sensor cables.
4-8
Service Manual
1.Remove the LVPS/HVPS card. See
HVPS card assembly removal" on page 4-10
more information.
for more information.
1. Remove the paper exit guide assembly. See
"Paper exit guide assembly removal" on
page 4-12 for more information.
7-4.)
"Rear cover removal" on
"Paper exit guide
for more information.
7-4.)
"LVPS /
for