Dukane 403570-01 User Manual page 52

Dual Servo Spin Welder User's Manual
Setting Time and Date
On Touch Screen
The time and date displayed on the touch screen are
preset at the factory for US Central Standard Time.
They can be changed using the following procedure:
1. Press the upper left-hand corner (marked by 1 in
Figure 5-37) and lower left-hand corner (marked
by 2) at the same time. The screen shown in Figure
5-38 should appear.
2. Press the "Clock" button. The screen shown in
Figure 5-39 should appear.
3. To change the date and time, first enter a numeric
value. Then press the corresponding button associ-
ated with that value. For example, to set the month
to May, press 5 and then the "Mon" button.
4. After setting the time and date, press the "Exit"
button on this screen and on the next screen.
5. Wait several seconds for the touch screen to return
to normal operation before welding.
Page 4
Figure 5-37 Touch Screen - Time and Date 1
Figure 5-38 Touch Screen - Time and Date 2
Figure 5-39 Touch Screen - Time and Date 3
Dukane Manual Part No. 403-570-01