Dukane 403570-01 User Manual page 51

Section 5 - Touch Screen Menus
The field is used to specify an angular
Home Offset (Deg .)
offset of the homing spin orientation. The tooling hub
RUN
home orientation is set at the factory such that the slot
in the hub shown in Figure 3-2a is closest to the front
of the machine. This position is the 0 degree reference
for the spin motor and all spin orientations are defined
PRE-
SETUP
relative to it. Unless a specific situation requires a non-
WELD
WELD
zero offset, it is most convenient to retain the factory
POST-
WELD
default value.
SELECT
TOOLS
The button is used to set the password,
Set Password
SETUP
which must subsequently be entered to change
programmed machine settings. The default password is UTILITIES
0 (zero) so that password–protected screens are easily
accessed by just pressing the key on the
Enter Enter
SYSTEM
SETUP
screen. The password is a numerical
Password Code
Set Password
value with a maximum 10–digit value of 4 294 967
295. The password–protected screens and menus are
Figure 5–35 Password-Protected Screens and
shown in Figure 5–35.
Menus
The buttons English, French, Czech, and German set
the active language on the welder. When one of these
buttons is pressed, the menu language changes to the
selected language and remains in effect while the welder
is powered up. To preserve the language selection
between power cycles, press the Save Language
Select button.
The button displys a screen with software
Software Info
revisions of the welder components as shown in Figure
5-36.
Figure 5–36 Welder Software Information
Page 45
Dukane Manual Part No. 403-570-01