Dual Servo Spin Welder User's Manual
Operational Switches
Emergency Stop Switch
A red Emergency–Stop (
in the center of the base as shown in Figure 4–3. The
emergency stop switch must be in its reset position
before the operate switches will function. To reset
the Emergency Stop, twist the large red button about
45 degrees clockwise, which will cause the button to
spring out. This is depicted in Figure 4–4.
Page 4
) switch is located
E–STOP
Left
Run
Switch
Lower Fixture
Lower Fixture
E–Stop Switch
Figure 4–3 Operate Switches and E–Stop
Figure 4–4 Setting and Resetting the E–Stop
Dukane Manual Part No. 403-570-01
Right
Run
Switch