Dukane 403570-01 User Manual page 105

Slide Kit Connector
The slide kit interface is a round 16–pin connector
located directly to the right of the base interface
connector on the rear of the thruster. The Dual Servo
Spin Welder is prewired to accept a Dukane slide kit
without any modification or reprogramming of the
press. The connector is shown in Figure 3–8. The
connector will interface to a Left/Right or an In/Out
slide kit, and provides activation signals to extend and
retract the slide table as well as readouts of the table
position switches. It also provides an input for a signal
from a part presence sensor. The pin numbers for the
connector are shown in Figure A–3. The pin assignments
and signal descriptions are given in Table A-III.
Pin Signal Description
1 Ground
2 (No Connection)
3 Slide Out Sense (Left) Input
4 Output Common
5 Top-of-Stroke Output (Closed at TOS)
6 Slide In Sense (Right) Input
7 In/Out Slide Identificaiton Input
8 Left/Right Slide Identificaiton Input
9 Part Presence Sensor Input
10 Ground
11 Slide In (Right) Output
12 Slide Home Status Output
13 Ready Status Output
14 Slide Out (Left) Output
15 Ground
16 +24V DC Switched
(Power OFF when Abort switch pushed)
Table A-III Pin Assignments and Signal Description for the Slide Kit Connector
Dukane Manual Part No. 403-570-01
1
3
7
11
15
Figure A–3 Slide Kit Connector
Ground connection
---
Activate when slide is in Out (Left) position
Output common connection
ON when press is at Top-of-Stroke position
Activate when slide is in In (Right) position
Activate to designate connected slide as In/Out type (ensure Pin 8
is disconnected)
Activate to designate connected slide as Left/Right type (ensure Pin
7 is disconnected)
Activate when part presence is sensed
Ground connection
ON when welder calls for slide to move to the In (Right) position
ON when slide is in Home position
NOTE: home slide position is Out (Left)
ON when welder is ready to initiate a weld cycle
ON when welder calls for slide to move to the Out (Left) Position
Ground connection
+24V DC switched connection
2
6
10
14
16
Function
Appendix A
Page