Dukane 403570-01 User Manual page 106

Dual Servo Spin Welder User's Manual
Data Port Connector
The computer interface connector is located on the
back of the welder above the power switch as shown
in Figure A-4. It provides a computer connection
to export part data and weld profile graphs. The pin
numbers for the connector are shown in Figure A–4.
Automation Wiring
If the Dual Servo Spin Welder will be used in
Automation mode, the signals normally generated
by the optical switches and abort switch must be
reproduced. Figure A-6 shows a wiring diagram and a
description of the required signals.
Page 100
Figure A–4 Data Port Connector Location
5
5
9
9
Figure A–5 Data Port Connector Pins
Dukane Manual Part No. 403-570-01
1
1
6
6