Dukane 403570-01 User Manual page 50

Dual Servo Spin Welder User's Manual
[.15 in.] above tooling contact, if possible) and press
the button. The stop block will be moved
Set Position
up, and a flashing circle will appear next to the
button when this process is complete, indicating that
the proximity switch is active. Press the
to return to the
SYSTEM SETUP
The button controls whether the weld
Data Export
parameter data displayed on the
Rotations, etc.) is sent out to a computer connected to
the welder after each cycle (refer to Chapter 8). Pressing
the button toggles between
The button controls whether the weld
Graph Export
profile data captured for the last weld is sent out to a
computer connected to the welder after each cycle
(refer to Chapter 8). This data includes the spin torque,
spin orientation, vertical thrust, vertical position, and
vertical speed. It is displayed in graphical format
in the Utility and can be exported to an ASCII file.
Pressing the button toggles between
The time required to transfer the data for this option
can be significant (several seconds, depending on weld
duration) and may adversely affect cycle rate as the
welder will not be ready to run another cycle until the
transfer is complete.
The button toggles from
Start Type
each time it is pressed. Manual is used for most
operations. is used in an automated
Automatic
system and requires a switch closure contact on the User
I/O HD-15 connector (see Figure 3–9). A pinout of the
User I/O connector and automation wiring information
are provided in Appendix A.
Page 44
DOWN
button
DONE
screen.
screen (Weld Time,
RUN
and states.
On Off
and states.
On Off
to
Manual Automatic
Figure 5–34 Vertical Lower Limit Setup Screen
with Set Position Button
Dukane Manual Part No. 403-570-01