Terminal Server Configuration Using Realport - Digi PortServer TS 8 Configuration And Administration Manual

Terminal Server Configuration Using RealPort

In this example, the PortServer TS 8/16 is simply providing ports for the LAN-based host using
RealPort. The configuration is exceedingly simple because port attributes are configured on the host
itself.
Related Information
For more information on configuring:
• The Ethernet interface, see "Configuring the IP Address" on page 2-1
• RealPort, see "Configuring Ports for RealPort" on page 3-1
Illustration
Configuration
set config ip=192.250.150.11 submask=255.255.255.0
set ports range=2-4 dev=rp
Configuration Notes
1. The set config command configures the internet address and mask for PortServer TS 8/16 Ether-
net interface.
2. The set ports command configures ports 2, 3, and 4 for Realport. This command specifies
dev=rp, which is an appropriate device type for RealPort.
17-4
192.250.150.11
Modem
Terminal
Printer
Terminal Server Configuration Using RealPort
(1)
(2)