Configuring Static Routes - Digi PortServer TS 8 Configuration And Administration Manual

Hide thumbs Also See for PortServer TS 8:
Table of Contents

Advertisement

Configuring Static Routes

This section describes how to configure PortServer TS 8/16 for static routes.
Related Information
See the set route command in the Digi One/PortServer TS Command Reference.
Procedure
To configure a static route over a PPP link, enter the following command:
set route net= addr mask=mask metric=hops wanname=interface gateway=gateway
where
addr is either the IP address of a system to be reached over this route or the network address of
the subnet that is to be reached on this route
mask is the mask to use for interpreting the IP address.
metric is the number of hop to the destination
interface is either ether if this route is over the Ethernet interface or the name of a user if the
route is over a PPP link
gateway is the IP address of the device that is the next hop to the destination
Example: Route Using the Ethernet Interface
In this example, a route to a subnet is created over the Ethernet interface. Key features include the
following:
The address on the net field is a subnetwork address, not the IP address of a specific device
The wannane=ether, indicating that this route is over the Ethernet interface
The metric field indicates that packets to this subnet will pass through two routers
The gateway field indicates that all packets using this route are to be forwarded to the device at
IP address 191.21.21.2.
set route net=199.21.33.0 mask=255.255.255.0 metric=2 wannname=ether gateway=199.21.21.2
Example: Route Using a PPP Link
In this example, a route to a subnet is created over the Ethernet interface. Key features include the
following:
The address on the net field is IP address of a specific device, not a subnetwork address
The wannane is the name of a PPP user.
The metric field indicates that packets to this subnet will pass through two routers
The gateway field indicates that all packets using this route are to be forwarded to the device at
IP address 191.21.21.2.
set route net=199.21.33.44 mask=255.255.255.255 metric=2 wannname=ppp1 gateway=199.21.21.2
Configuring IP Routing
9-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Portserver ts 16Connectware portserver ts 8/16

Table of Contents