Denso BHT-7500S User Manual page 80

[4.5] Setting the communications environments
After the BHT is initialized, the interface port and communications parameters are set
as listed in the default table below. Do not access them unless necessary.
Interface port
Communications protocol
Communications parameters
for the optical interface port
TRANSMIT SPEED
PROTOCOL
(Protocol options)
Listed below are the default communications parameters for the direct-connect inter-
face.
Communications parameters for
the direct-connect interface port
TRANSMIT SPEED
PARITY BIT
(Vertical parity)
DATA BIT
(Character length)
STOP BIT
PROTOCOL
(Protocol options)
Optical (Optical interface port)
BHT-protocol
Defaults
9600 bps
SERIAL No.: ON (Adds serial numbers
to data blocks.)
H. PARITY: ON (Adds a horizontal
parity.)
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore
Defaults
19200 bps
None
8 bits
1 bit
SERIAL No.: ON (Adds serial numbers
to data blocks.)
H. PARITY: ON (Adds a horizontal
parity.)
LINKUP TIME: 30 seconds
FIELD SPACE: Ignore
60