Denso BHT-7500S User Manual page 107

PING run-time messages (that will appear in the middle of the LCD)
Message
Waiting
Opening TCP/IP
Routing TCP/IP
PING start
Device error
TCP/IP error
PING termination messages (that will appear in the bottom of the LCD)
Message
PING end
PING aborted
PING error
(2) PING parameters screen
SET PING
1:DESTINATION IP
[XXX.XXX.XXX.XXX ]
2:DATA SIZE [XXXXX]
3:INTERVAL [XXXXX]
4:TIMEOUT [XXXXX]
5:COUNT [XXXXX]
6:SEND TYPE
TYPE1 TYPE2
Chapter 2. Getting Started the BHT and System Mode
Displays when:
Setting up PING.
Opening devices.
Connecting to the TCP/IP communications pathway.
Starting PING.
Failed to open a device.
Failed to connect to the TCP/IP communications pathway.
Displays when:
PING has ended normally.
PING has aborted.
An error has occurred during running of PING.
Selecting "2:SET PING" on the TEST PING menu
calls up the screen shown at left where the current
settings are displayed.
1 DESTINATION IP : Specifies the IP address of
2 DATA SIZE
3 INTERVAL
4 TIMEOUT
5 COUNT
6 SEND TYPE
The entry range for each of "2:DATA SIZE" through
"5:COUNT" items is listed on the next page.
Select a desired item by using the numerical keys
or
a host computer that you
want to ping.
: Specifies the data size of an
echo request.
: Specifies the echo request
intervals (in units of 100
ms).
: Specifies the timeout period
(in units of 100 ms) for an
echo request.
: Specifies the number of
echo requests to be sent.
: Selects the echo request
send timing TYPE 1 or TYPE
2 (described on page 89).
and keys.
87