Line Condition Status Display - ZyXEL Communications U-336R/RE User Manual

Dialing Indicator
The V34 LED will flash on and off for 1/2 second intervals to
indicate that the modem is dialing. This flash will continue after
dialing until a carrier is detected. Therefore, the V34 LED will also
flash during leased-line modem connections when one modem is
trying to handshake but the other modem is not turned on.
Handshaking And Retrain Indicator
The V34 LED will flash on and off for in 1/2 second intervals to
indicate that the modem is handshaking or retraining.

Line Condition Status Display

Regarding data being transmitted over telephone line circuits, there
are many kinds of line impairments that can affect the data being
received by the remote modem.
Your modem can measure four major line impairments. From the
impairment readings, you can understand the current line condition.
Your modem also logs line events over a long period, so you know
what the line condition has been. We will describe these readings
and logs as follows:
O O N : R
OTE EADINGS ARE ONLY AVAILABLE WHEN USING THE
RS-1612
AND SHOULD ONLY BE USED AS A REFERENCE
Signal to Noise Ratio (S/N)
This reading is expressed in 1 dB resolution. The higher the speed,
the higher the S/N ratio required. The modem measures the S/N
ratio by measuring the distance between the demodulated signal
point and the ideal signal point. For V.32/V.32bis, the modem-
measured S/N ratio is generally about 2 dB higher than what is
actually on the line because the modem rejects some of the out-of-
band noise. For V.22/22bis, the difference can be as high as 8 dB
because the modem only uses part of the 3 KHz bandwidth and
rejects more than half of the voice band noise.
120 Diagnostics & Troubleshooting
. T
RACK SYSTEM HE READINGS DISPLAYED ARE NOT MEASUREMENTS
U-336R/RE
INSTALLED IN
.