Indicator Lights - ZyXEL Communications U-336R/RE User Manual

received from the remote modem will be returned to the remote
modem. This test is applicable when the remote modem does not
provide V.54 Remote Digital Loopback capability. This test can be
initiated by the local modem when the modems are on-line.
Remote Digital Loopback Test (AT&T6)
This test will request the remote modem to do a digital loopback.
During testing, the local modem will send a remote digital loopback
request to the remote modem according to V.54. If the remote
modem supports V.54 and is programmed to grant this kind of
request, it will resend all of the received data back to the local
modem. The local terminal or computer will receive all of the data
it sends out. This test is applicable when the remote modem and
local modem both provide V.54 Remote Digital Loopback
capability. This test can be initiated by either modem when the
modems are on-line.
Remote Digital Loopback with Self-test (AT&T7)
This test generates data from the modem itself instead of input data
from the RS-232 interface. The data will go through the same path
as it would with the Remote Digital Loopback Test. In
asynchronous mode, the pattern consists of printable ASCII
characters. You can see the results on the screen. In the
synchronous mode, the pattern is made up of scrambled binary 1,
and the Throughput Meter of the initiated modem will change to a
Bit Error Rate Meter. This test can be initiated by either modem
when the modems are on-line.

Indicator Lights

Retransmission Indicator
In the error control mode, an error occurring in the link will cause
the data to be re-transmitted. At the same time, the RI LED will
flash. This also indicates the quality of the line.
Diagnostics & Troubleshooting 119