Chapter 6. Rs-232; Introduction - Datalogic QuickScan L QD 2300 Product Reference Manual

Introduction

This chapter describes how to set up the scanner with an RS-232 host. The RS-232 in-
terface is used to connect the scanner to point-of-sale devices, host computers, or other
devices with an available RS-232 port (e.g., com port).
If the host is not listed in
communication parameters to match the host.
The scanner uses TTL RS-232 signal levels, which will interface with most
system architectures.
NOTE
Throughout the programming bar code menus, default values are indicated with asterisks
*
( ).
Product Reference Guide
, refer to the documentation for the host device to set
Table 6
*Baud Rate 57,600
* Indicates Default
Chapter 6
RS-232
Feature/Option
31