Keyboard Wedge Parameter Defaults - Datalogic QuickScan L QD 2300 Product Reference Manual

Keyboard Wedge Interface
To connect the Keyboard Wedge interface Y-cable:
Interface cables vary depending on configuration. The connectors illustrated
in Figure 1 are examples only. The connectors may be different than those
illustrated, but the steps to connect the scanner remain the same.
NOTE
1. Turn off the host and unplug the keyboard connector.
2. Attach the modular connector of the Y-cable to the cable interface port on the scanner.
3. Connect the round male DIN host connector of the Y-cable to the keyboard port on the
4. Connect the round female DIN keyboard connector of the Y-cable to the keyboard con-
5. If needed, attach the optional power supply to the connector in the middle of the Y-cable.
6. Ensure that all connections are secure.
7. Turn on the host system.
8. Select the Keyboard Wedge host type by scanning the appropriate bar code from
9. To modify any other parameter options, scan the appropriate bar codes in this chapter.

Keyboard Wedge Parameter Defaults

Appendix B, Standard Defaults
See
gies, and miscellaneous default parameters.
NOTE
Table 9
scan the appropriate bar code(s) in the Keyboard Wedge Host Parameters section begin-
ning on
Table 9. Keyboard Wedge Defaults
Parameter
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type
Country Types (Country Codes)
Ignore Unknown Characters
Keystroke Delay
Intra-Keystroke Delay
56
(See Installing the Interface Cable on page
host device.
nector.
board Wedge Host Parameters on page
lists the defaults for Keyboard Wedge host parameters. To change any option,
.
page 57
6.)
57.
for all user preferences, hosts, symbolo-
Default
IBM PC/AT& IBM PC Compatibles
North American
Send
No Delay
Disable
Page Number
1
57
58
59
60
60
QuickScan
Key-
®
L