Scan Line Width
Scan a bar code below to set the scan line width. A full scan line width is the default. The
medium scan line width is useful for scanning menus or pick-lists.
*
Full Width
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The de-
fault Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan the two numeric bar codes
from
bers must be padded with a leading zero. For example, to set an On Time of 0.5 seconds,
scan the bar code below, then scan the "0" and "5" bar codes. If an error is made, or the
selection needs to be changed, scan
Product Reference Guide
This feature applies to scanners in Trigger Single Mode only.
NOTE
Appendix E,
Keypad, that correspond to the desired On Time. Single digit num-
This feature applies to scanners in Trigger Single Mode only.
NOTE
Medium Width
Cancel on page
166.
Laser On Time
Scan Line Width
25