Fn1 Substitution Values; Transmit "No Read" Message - Datalogic QuickScan L QD 2300 Product Reference Manual

General Features

FN1 Substitution Values

The Wedge and USB HID Keyboard hosts support an FN1 substitution feature. When
enabled, any FN1 character (0x1b) in an EAN128 bar code is substituted with a value.
This value defaults to 7013 (Enter Key).
To select an FN1 substitution value via bar code menus:
1. Scan the bar code below.
*
Set FN1 Substitution Value
2. Look up the keystroke desired for FN1 Substitution
3. Enter the 4-digit substitution value by scanning each digit in
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for keyboard wedge, scan the
on page
To enable FN1 Substitution for USB HID keyboard, scan the
tion on page

Transmit "No Read" Message

Scan a bar code below to select whether or not to transmit a No Read message. When
enabled, the characters NR are transmitted when a bar code is not decoded. When dis-
abled, if a bar code does not decode, nothing is sent to the host.
*
Disable No Read
30
Sets for the currently installed host interface.
63.
82.
inAppendix F, ASCII Character
Appendix E, Keypad.
Enable FN1 Substitution
Enable FN1 Substitu-
Enable No Read
QuickScan
®
L