Chapter 5. General Features; User Preferences; Scanning Sequence Examples; Errors While Scanning - Datalogic QuickScan L QD 2300 Product Reference Manual

User Preferences

User preferences for the general features listed in this chapter can be selected using the
programming bar codes that accompany each feature description. To set feature values,
scan a single programming bar code or a short bar code sequence as instructed for each
feature. The settings are stored in non-volatile memory and are preserved even when the
scanner is powered down.
Typically, a scanner ships with the settings shown in
on page 20
fault values suit requirements, programming may not be necessary.
If not using a USB cable, select a host type (see each host chapter for specific host infor-
mation) after the power-up beeps sound. This is only necessary upon the first power-up
when connecting to a new host.
To return all features to their default values, reference the topic, Return to Factory De-
faults. Throughout the programming bar code menus, default values are indicated with
asterisks (*).

Scanning Sequence Examples

In most cases, scanning one bar code sets the parameter value. For example, to set the
beeper tone to high, scan the High Frequency (beeper tone) bar code on
scanner issues a fast warble beep and the LED turns green, signifying a successful param-
eter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, re-
quire the scanning of a sequence of bar codes. See these parameter descriptions for this
procedure.

Errors While Scanning

Unless otherwise specified, when an error is made during a scanning sequence, just re-
scan the correct feature bar code(s).
Product Reference Guide
General Features
(also see Appendix B, Standard Defaults
*
Indicates Default
Chapter 5
User General Feature Defaults
*
High Frequency
for all host defaults). If the de-
Feature/Option
page 19. The
19