Parameter Defaults; Host Parameters - Datalogic QuickScan L QD 2300 Product Reference Manual

RS-232 Parameter Defaults
Table 5
scan the appropriate bar code(s) provided in the Parameter Descriptions section begin-
ning on
Appendix B, Standard Defaults
See
gies, and miscellaneous default parameters.
NOTE
Table 5. RS-232 Defaults
RS-232 Host Parameters
RS-232 Host Types
Baud Rate
Parity Type
Stop Bit Select
Data Bits (ASCII Format)
Check Receive Errors
Hardware Handshaking
Software Handshaking
Host Serial Response Time-out
RTS Line State
Beep on <BEL>
Intercharacter Delay
Nixdorf Beep/LED Options
Ignore Unknown Characters
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings (
lecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti,
Omron, or terminal sets the defaults listed in
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS
terminal enables the transmission of code ID characters listed in
These code ID characters are not programmable and are separate from the Transmit
Code ID feature. The Transmit Code ID feature should not be enabled for these termi-
nals.
Product Reference Guide
lists the defaults for RS-232 host parameters. If any option needs to be changed,
.
page 33
for all user preferences, hosts, symbolo-
Parameter
RS-232 Parameter Defaults
Default
Standard
9600
None
1 Stop Bit
8-Bit
Enable
None
None
2 Sec
Low RTS
Disable
0 msec
Normal Operation
Send Bar Code
.
Table 6
Table 7 on page 34
Page Number
36
37
38
39
39
40
42
44
45
46
46
47
48
48
). Se-
Table 6
.
33