Powerscan® 7000 2D; To Add A Data Format - Datalogic POWERSCAN 7000 2D Imager Product Reference Manual

Data Formatting

To Add a Data Format

Step 1.
Scan the Enter Data Format symbol
Step 2.
Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate
formats. (Alternate formats allow you "single shot" capability to scan
one bar code using a different data format. After the one bar code
has been read, the imager reverts to the primary data format. See
page 5-6.) If you are programming the primary format, scan 0 using
the Programming Chart on page B-5
gramming an alternate format, scan 1, 2, or 3, depending on the alter-
nate format you are programming.
Step 3.
Terminal Type
Refer to Supported Terminals on page 2-2
number for your PC. Scan three numeric bar codes on the
ming Chart on page B-5
(you must enter 3 digits). For example, scan 124 for a USB key-
board.
The wildcard for all terminal types is 099.
NOTE
Step 4.
Code I.D.
In Symbologies, find the symbology to which you want to apply the
data format. Locate the Hex value for that symbology and scan the 2
digit hex value from the
ual.
Step 5.
Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the
ming Chart on page B-5
entered as 0050. 9999 is a universal number, indicating all lengths.)
Step 6.
Editor Commands
Refer to Data Format Editor Introduction on page
5-2
(page 5-5).
of this manual. If you are pro-
and locate the Terminal ID
to program the imager for your terminal ID
Programming Chart on page B-5
of this manual. (Note: 50 characters is
PowerScan
Program-
of this man-
Program-
5-1. Scan the sym-
®
7000 2D