Chapter 2 Terminal Interfaces; Terminal Id - Datalogic POWERSCAN 7000 2D Imager Product Reference Manual

Terminal Interfaces
Use this section to configure interface features
for imager models using RS-232 and USB inter-
faces.
For Imager models using UKBW interfaces, do
NOTE
not use this section but refer to the UKBW Con-
nectivity Guide available for download from the
website listed on the back over of this manual.
In most cases and mainly in Concurrent Aiming
mode an external power supply is required.

Terminal ID

If your interface is not a standard PC AT, refer to
, and locate the Terminal ID number for your PC. Scan the
page 2-2
bar code below, then scan the numeric bar code(s) on the
minal ID
gramming Chart on page B-5
your terminal ID. Scan
Product Reference Guide
Chapter 2
of this manual to program the Imager for
to save your selection.
Save
Supported Terminals on
Ter-
Pro-
2-1