OCR Programming
4.) when the modulo 11 check character "0123456789X" is pro-
grammed.
Please note that all these commands can be combined into a single serial
programming command:
OCRENA2,TMP"ISBNggggggggggggctCdddd hdddEtCdddd
hddddE",GPG"0123456789-",GPH"P\",CHK"0123456789X".
These commands can be encoded into the following Aztec Code symbol:
OCR Template Codes
Reading more than three rows of OCR is not
recommended. Contact the factory if you have
an application that requires reading four or
more rows of OCR.
NOTE
Enter OCR Template †
Enter User-Defined
Variable "h"†
†
One or more two-digit numbers and
Programming Chart on page B-5
symbol. Refer to the
8-16
Enter User-Defined
Variable "g"†
Save
are required after reading this programming
of this manual.
PowerScan
®
7000 2D