Datalogic POWERSCAN 7000 2D Imager Product Reference Manual page 74

Symbologies
Code 39 Check Character
indicates that the imager reads and transmits bar code
No Check Character
data with or without a check character.
When Check Character is set to , the unit only
Validate, but Don't Transmit
reads Code 39 bar codes printed with a check character, but will not
transmit the check character with the scanned data.
When Check Character is set to , the imager only
Validate and Transmit
reads Code 39 bar codes printed with a check character, and will trans-
mit this character at the end of the scanned data. Default = No Check
Character.
* No Check Character
Validate, but Don't Transmit
Validate and Transmit
Code 39 Message Length
Scan the bar codes below to change the message length. Refer to
Mes-
for additional information. Mini-
sage Length Description on page 6-2
mum and Maximum lengths = 0-48. Minimum Default = 0, Maximum
Default = 48.
Minimum Message Length
Maximum Message Length
®
6-6 PowerScan 7000 2D