To Add A Prefix Or Suffix - Datalogic POWERSCAN 7000 2D Imager Product Reference Manual

To Add a Prefix or Suffix:

Step 1.
Scan the Add Prefix or Add Suffix symbol
Step 2.
Determine the 2 digit Hex value from the Symbology Chart (included
in the Symbology Chart on page
want to apply the prefix or suffix. For example, for Code 128, Code ID
is "j" and Hex ID is "6A".
Step 3.
Scan the 2 hex digits from the
manual or scan 9, 9 for all symbologies.
Step 4.
Determine the hex value from the
Page 1252) on page
Step 5.
Scan the 2 digit hex value from the
of this manual.
Step 6.
Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7.
To add the Code I.D., scan
To add AIM I.D., scan
To add a backslash (\), scan
To add a backslash (\) as in Step 7, you must
scan 5C twice – once to create the leading back-
slash and then to create the backslash itself.
NOTE
Step 8.
Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Product Reference Guide
Prefix/Suffix Overview
(page
A-1) for the symbology to which you
Programming Chart on page B-5
ASCII Conversion Chart (Code
A-4, for the prefix or suffix you wish to enter.
Programming Chart on page B-5
5 C 8 0
, , , .
5 C 8 1
, , , .
5 C 5 C
, , , .
4-5).
of this
4-3