Plug And Play; Connecting The Imager With An Rs-232 Serial Port - Datalogic POWERSCAN 7000 2D Imager Product Reference Manual

Getting Started

Plug and Play

Plug and Play bar codes provide instant imager set up for commonly
used interfaces.
After you scan one of the codes, power cycle
the host terminal to have the interface in effect.
NOTE
Connecting the imager with an RS-232
Serial Port
These instructions are for use with the RS-232
cable. This includes both Power Off the Termi-
nal (P.O.T.) and external power.
NOTE
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
For the imager to work properly, you must have
the correct cable for your type of terminal/com-
puter.
NOTE
Cable Connector
Retainer Boss
Captive
Screws
1-4
For 220-230 VAC
adapters, the
cord must be
facing down as
shown in the
illustration. If
installed upwards,
it will pose an
undue strain on the
socket outlet.
®
PowerScan 7000 2D