Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On bar code, below. However, if you want to turn just the lights
off, scan the Lights Off bar code.
This setting does not affect the aimer light. The
aiming light can be set using Aimer Mode (see
Aimer Modes on page 3-13
NOTE
* Lights On
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle
for the specified time. To prevent the imager from powering down, set
this time-out to 0. Scan the bar code below, then set the time-out by
scanning digits (from 0 - 999,999 ms) from the
, then scanning Save. Default = 120,000 ms.
page B-5
Product Reference Guide
Illumination Lights
).
Lights Off
Programming Chart on
Imager Time-Out
3-11