Smooth Fitness CE-8.0LC Owner's Manual page 9

"A I
SSEMBLY NSTRUCTIONS"
S –
TEP 11 Console Fixed Bracket Assembly
NOTE: For shipping purpose, the 4 x Button Head Bolts (M8xp1.25x12mm) (87) and 4 x Lock Washers (M8)(66) are
attached on the Upright Post (4).
a. Remove the 4 x Button Head Bolts (M8xp1.25x12mm)(87) and 4 x Lock Washers (M8)(66) from the Upright Post
(4).
b. Attach the Console Fixed Bracket (43) onto the Upright Post (4) and secure with the 4 x Button Head Bolts
(M8xp1.25x12mm)(87) and 4 x Lock Washers (M8)(66)
S –
TEP 12 Stationary Handlebar & Wire Assembly
NOTE: For shipping purpose, the Button Head Bolts (M8xp1.25x16mm)(88) and Lock Washers (M8)(66) are attached
on the Stationary Handlebar (5).
a. Remove the 4 x Button Head Bolts (M8xp1.25x16mm)(88) and 4 x Lock Washers (M8)(66) from the Stationary
Handlebar (5).
b. Connect the Middle Pulse Sensor Wire (112) and the Lower Pulse Sensor Wire (113) to the Stationary
Handlebar (5).
NOTE: After connecting the wires' pins, slightly and gently pull two sides of wires to test and
make sure whether the wires are fully connected.
c. Insert the Stationary Handlebar (5) into the Upright Post (4) and secure with the 4 x Button
Head Bolts (M8xp1.25x16mm)(88) and 4 x Lock Washers (M8)(66).
S
TEP 10
Assembly
damage the Middle Pulse Sensor Wire
(112) while assembling STEP 9.
Slide the Console Bracket (18) onto the
Upright Post (4) as the FIG1 illustration
shows on the top right corner.
9
–
Console Bracket
CAUTION: Be careful not to