Operation Mode Setting Procedure - Panasonic AK-HRP200G Operating Instructions Manual

Operation.modes.
(continued)
Operation.mode.setting.procedure
In the factory default state, connect the CCU, remote camera or camera recorder to the unit and then set the operation mode.
In the factory default state, connect the CCU, remote camera or camera recorder to the unit
When connecting to a CCU
with a serial connection
1. Select CCU in the serial
setting in setup mode
(→ page 17).
2. Connect to the CCU in serial
connection mode and then
start operation.
<Note>
z About.the.IP.connection.mode.settings .
Do not start Easy IP Setup Software and ROP Setup Software during operation.
The ROP will be disconnected, which in turn may cause a problem with operation.
(for details, refer to Operating Instructions <Basics>).
Operation in serial connection mode
When connecting to a remote
camera with a serial connection
1. Select remote camera in the
serial setting in setup mode
(→ page 17).
2. Connect to the remote camera
in serial connection mode and
then start operation.
When connecting to a camera
recorder with a serial connection
1. Select camera recorder in the
serial setting in setup mode
(→ page 17).
2. Connect to the camera
recorder in serial connection
mode and then start operation.
Operation in IP connection mode
1. In Easy IP Setup Software,
set the IP addresses of the
CCUs and remote cameras
(→ page 33).
・ Set the IP address of the
camera recorder from the
menu on the unit.
2. In ROP Setup Software, set the
remote camera configuration
file to assign to each camera
number (→ page 35).
3. Connect to the CCU and remote
cameras/camera recorders in IP
connection mode and then start
operation.
5