Changing Needle; To Remove And Attach The Foot Holder; To Remove; To Attach - Kenmore 18221 - Drop-In Bobbin Sewing Machine Owner's Manual

Changing Needle
_i_ Needle clamp screw
_2_Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw£1_ by
turning it counterclockwise. Remove the needle from the
needle clamp £2_.
[] Insert a new needle into the needle clamp_2_with the
flat side to the rear. When inserting the needle into the
needle clamp _2_,push it up as far as it goes. Tighten
_1 _ firmly by turning it clockwise.
the needle clamp screw ,_j
[] To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
(i_:Thumb screw
_2_Foot holder
_3_: Presser bar
• _ remove
Remove the thumb screw _1_ by turning it counterclockwise
with a screwdriver.
• "b attach
Match the hole in the foot holder _2_with the threaded
hole in the presser bar _3_:.Fit the thumb screw @_ into
the hole. Tighten the screw _1_ by turning it clockwise with
a screwdriver.
Changing Presser Foot
_1_Snap-on button (red button)
_2_Groove
_3_Pin
• "b remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button _1_ on the back of the foot holder.
• "b attach
Place the selected presser foot, so that the pin_2_on the
foot lies just under the groove ,_3_ o n the foot holder. Lower
the presser bar to lock the foot into place.
f
F
F
[]
Flat side
Lado piano Needle
Meplat vers Aguja
Aiguille
[]
f
\\
\\\
J
J
J
-x
10