Changing Needle; To Remove And Attach The Foot Holder; To Remove; To Attach - Kenmore 385.16528000 Owner's Manual

Changing
Needle
Needle clamp screw
(_) Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning the
handwheet counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw_)by
turning it counterclockwise. Remove the needle from the
needle clamp _.
[] Insert a new needle into the needle clamp_)with the
fiat side to the rear. When inserting the needle into the
needle clamp (_, push it up as far as it goes. Tighten
the needle clamp screw (_ firmly by turning it clockwise.
[] To check for a good needle, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the fiat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
(_ Thumb screw
Foot holder
(_ Presser bar
• To remove
Remove the thumb screw _1_ by turning it ceuntercteck
wise with a screwdriver.
• To attach
Match the hole in the foot holder _with the threaded
hole in the presser bar _. Fit the thumb screw _l_into
the hole. Tighten the screw _l_by turning it clockwise with
screwdriver.
Changing
Presser Foot
(_ Snap-on button (red button)
Groove
(_ Pin
• To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button _t_on the back of the foot holder.
• To attach
Place a selected presser foot so the pin _ on the foot lies
just under the groove _ on the foot holder. Lower the
presser bar to lock the foot in place.
S
[]
Fiat side
Lade piano _ N dl
M6p at Vers Aguja
Aiguille
[]
[]
J
J
J
10