Extension Table; Detaching The Table; Attaching The Table; Accessory Box - Kenmore 385.15008100 Owner's Manual

Extension Table
• Detaching the table
Pull the table away from the machine, as illustrated for
"free-arm" sewing of cuffs and sleeves.
• Attaching the table
Push the extension table until it snaps into the machine.
(_0 Extension table @ Tab
(_) Pin @ Free-arm
_) Hole
• Accessory box
Open the cover of the accessory box toward you.
Sewing accessories are conveniently located in the box.
Changing
Needle
(_0 Needle clamp screw
(_ Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning the
handwheet counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw(_0by
turning it counterclockwise. Remove the needle from the
needle clamp (_.
[] Insert a new needle into the needle clamp (_)with the
flat side to the rear. When inserting the needle into the
needle clamp _), push it up as far as it goes. Tighten
the needle clamp screw (_0 firmly by turning it clockwise.
[] To see if the needle is good, place the flat side of the
needle onto something fiat (e.g needle plate or glass).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
(_ Thumb screw
{_ Foot holder
(_ Presser bar
• TO remove
Remove the thumb screw _ by turning it counterclockwise
with a screwdriver.
• To attach
Match the hole in the foot holder (_with the threaded
hole in the presser bar _). Fit the thumb screw _0into
the hole. Tighten the screw(_l_by turning it clockwise with
screwdriver.
S
s
f
J
\
"¢
\
[]
Flat side 1
Lade plan0 Needle /
M6p!at vers Aguja /
Ague /
J
I
I<
%
I/ /
J
J
lO